1. Cleanse the shaft, the internal and outer holes of the bushing, and the interior gap of the hub. Get rid of any oil, paint or filth, location the bushing on the hub, and match the half holes to make complete holes (every entire hole will only be threaded on 1 side). Flippantly oil the threads and points of set screws or the threads and heads of cap screws. Loosely location the screws in the threaded holes on the hub aspect. Make positive the bushing is free of charge on the hub. Snap the assembly on to the shaft and position it in the sought after position. Tighten the screws alternately and evenly till all are restricted 5. Hammer the massive conclude of the bushing with a hammer and block or socket to keep away from hurt. The screw can now be turned a bit to the specified torque environment. Repeat this alternating hammering and screw retightening until finally the specified torque is arrived at. Fill all holes with grease to eliminate grime.